Hello All, I am remotely connected into a Cat 4500 + Supervisor V module via console cable and point to point connection from laptop to fa1 management interface on SupV. SupV module is running IOS 15.0(2)SG8. I am not able to physically change...
Hello All, I was wondering if I can run IOS 15.0(2)SG9 instead of 15.0(2)SG8 on a Catalyst 4506 with Supervisor V module? It does load just fine and appear to be working but do you think this will be fine in production? Any suggestions would ...
Hi Jon, I think you are absolutely correct. I reviewed the document you posted and indeed I did not see http as a supported vrf service. I had the client plug my patch cable into gi 2/3 and I assigned an IP address to that interface and I was ...
There was an issue when I tried to open the last pcap file in wireshark. Please use this one instead and remove the .txt extension and it should load ok. It looks like the connection gets reset by the catalyst when trying to access http or https on...
Hi Richard, No error, just not able to connect. I cannot even telnet to port 80 or 443 on the catalyst from laptop which would at least show me the port is open and daemon is up on the interface. It looks like it is not serving those daemons on t...
Here is the ACL list. I have not made any entries into this list and all of these are default at this time. Do I need to make an explicit allow ACL for http? Thanks!-S#show access-listExtended IP access list system-cpp-all-routers-on-subnet 10 p...
Hi Rakeshvelagala, Thank you for the response. Yes I have all of the following entries in the config. I do not get an error per se, but the port 80 and port 443 are not accessible from the laptop browser. The management interface is 192.168.1.25...
