Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Now that I look closer at the configuration you are using standard ACLs and filtering outbound. Standard ACLs will filter based on the source IP address and not the destination IP. So it appears that your ACLs only allow the Network assigned to the V...
Yes, just permit the traffic on both of the ACLs between the VLANs by inserting it using a sequence number.example (assuming you have an increment of 10): ip access-list standard TEST11 permit ip host x.x.x.x You can re-sequence the ACL after if yo...
You can do this by setting the security levels for the interfaces. Interfaces with higher security levels can pass traffic to interfaces with lower security levels but not vice versa unless explicitly defined. Interfaces with the same security level ...
