Good afternoon everyone. I have been referred to the Cisco Support Community for assistance by TAC. I was hoping that you can help me with an EEM script that I am somewhat able to get working. However, it does not meet my requirements 100%. Since...
Hello everyone. I seem to have an issue that I cannot find a solution to and was hoping the support community would be able to help. The platform I am trying this on is the RV042. I have updated the firmware to 4.2.3.03.The scenario for this confi...
Francesco,
Sorry for the late response. I had been in a workshop for the last few days and have not gotten back to testing this out. Can you review the following script and see if I have added the right ELSE statement like you suggested? I am not ...
Thank you for suggesting the ELSE statement. I will actually try that when I get back in the office. I should have thought of that! :)
I will keep you posted. I appreciate your time on all these suggestions!
Hello Francesco. Thank you for the reply. I have modified action 080 as you suggested, but left everything else the same.
BEFOREaction 080 regexp "(REGISTERING)+" "$line"
AFTERaction 080 regexp "(\b(?!REGISTERED\b)\w+)" "$line"
The phone currently is...
Thank you for replying Michael. The article did help me understand the RV042 much better.However, I guess I am looking into the wrong unit for what I am trying to accomplish. I am hoping that when the primary link fails (WAN1), I do not want any of...