Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,sorry if the issue has already been submitted to the community ...We've recently implemented a new wifi "area" using Cisco 1131AG access points and a couple of Integrated Cat3750-WLC (sw 4.2.112). This new area hosts both thin-clients and phon...
We've implemented a wifi area based on a few 1131AG access points and a couple of Cisco 3750 Integrated WLAN Controllers. We're now trying to use web authentication for our guest area. No problem in defining a GUEST WLAN and the associated VLAN. We'v...
Disassociations occur about every 30 minutes; I've disabled a few weeks ago the Session Timeout parameter (WLANs --> Edit --> Advanced --> Enable Session Timeout unchecked) but this change had no effect ...Thanks and regards,Sonia
Data rates for the 802.1 b/g standard (the one in use by wifi phones) are as follows:1 Mbps Supported 2 Mbps Supported 5.5 Mbps Supported 6 Mbps Supported 9 Mbps Supported 11 Mbps Mandatory 12 Mbps Supported 18 Mbps Supported 24 ...
Hi,further to my investigations I examined the Bug Toolkit more in depth.Could this issue be determined by one of the following two bugs ?- CSCsl30758 (no CCKM, no WLAN session timeout and WPA-auth correspond exactly to our configuration ...)- CSCso9...
Hi,session timeout has been disabled a couple of weeks ago, but this change had no effect on phones' behaviour.Exclusion is turned on with all the followings ENABLED: Excessive 802.11 Association Failures Excessive 802.11 Authentication Failures E...
Aggressive Load Balancing has never been turned on. We've already examined the Cisco web page you're indicating and we're a little bit confused. Our phones are using WPA2-PSK authentication (at the moment no 802.1x has been enabled) and are permanent...
