Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I recently built a wireless network for my client by tens of Meraki MR36 AP. I check AP status every day to make sure the network is fine. In general, there will be 300 to 600 devices on daily basis. It had been running for nearly 3 months and no co...
Confirmed there will be service impact to wireless client. Client balancing is enabled to evenly distribute client connection to nearby APs. I found that from the AP log shown '802.11 association rejected for client balancing'. I believe that when t...
Thanks PhilipDAth.The MR firmware is 30.6. I am very sure that no device will put in that area because that is a common access area. It is not secure to put personal or IoT device there.As a matter of fact, this problem just happened again yesterday ...
Good to hear Meraki releasing new update.My customer site is running 30.6 firmware on several dozens of MR36. I found that client count under Monitor>AP>Performance page from multiple AP, it showed more than 30 clients vary up and down on a Saturday ...
