Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi networkers,Simple question maybe, but I need some help with this one.I've got IPv4-network on which I now will implement IPv6(dual-stack) on a couple of subnets, to try it out and to learn more about IPv6.Okey, subnet A and subnet B is now dual-st...
Hi all,I'm about to upgrade the IOS-image on my ASA5550 and also at the same time upgrade the ASDM. I have a few questions about this event.Some info about the ASA5550;It's running IOS-version 7.2(4)ASDM-version 5.2(4)Total Flash is 256 MBTotal Memor...
Hi Phillip,Sorry but thats correct, i was trying to solve a problem in the fec0:0:0:1001::1/64 net. So because of that both pc's was placed in this 1001-net.But i'm trying to get my two pc's to receive IPv6-address via DHCP (Win2008-server) and i hav...
Hi Keith,Hmm, can't seem to find path mtu as icmp6 among the different Service's when editing the ACLv6-list? Right now i have allowed icmp6 and echo-reply6 in the ACLv6. I'm configuring the ASA via ASDM, not CLI.BRTom
Hi Philip,Sorry for answering late, I've been away from work for a while.Take a look at the notepad-doc, it's the route print from Test-PC1 and Test-PC2BRTom
Hi Gustavo,No it's okey, i'll understand you and i shall change the ip address range. It would be unwise not to.That command, ipv6 unicast-routing, i can see that command if i try too enable it. if i'm running conf t, ipv6 ? i can't see that command....
