Hello,
I'm trying to setup a Cisco WLC attached to an ISE server to complete the following:
- 802.1x authentication for devices that support 802.1x,
- MAB for legacy devices that don't support 802.1x.
The ISE is authenticating users with 802.1x...
Thanks Arne.
I was under the impression that it would still follow the Authorisation rules (Hit MAB first and the if there are no authenticated MAC's go to 802.1X). However, it sounds like this isn't the case?
I've managed to get the MAB working ...
Thank you for your reply Jason.
I've setup an additional SSID to test the MAB with. Is it possible to have an SSID setup with both to do MAB and dot1x authentication?
I'm using this default rule and can see the rule getting hits so I know that ru...
Thank you for your reply Jason.
I've setup an additional SSID to test the MAB with. Is it possible to have an SSID setup with both to do MAB and dot1x authentication?
I'm using this default rule and can see the rule getting hits so I know that ru...