Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I unfortunately have stumbled across a problem. We are trying to write a script that will pull information from our Cisco switches. What we are trying to obtain through SNMP is the equivalent of what you get via telnet when you use the 'show ...
I just spoke with one of my coworkers who is pretty familiar with Cisco and he said I need to add an access-list on my outside interface to allow 'domain' traffic in. The outside interface is set to security0 so he believes it was automatically deny...
Following these directions, I can't seem to get any connectivity on my outside interface connected to my cable modem. My inside interface is fine, and it can assign IP addresses to the connected computers, but the outside one fails to get an IP addr...
Milan,Thanks for all the time you've spent helping out. After talking it over with my boss and explaining the the cons of trying to use SNMP to do this, I've convinced him to stick with the method they were using that worked from the beginning. Try...
Milan,Thank you very much for the help. This has definitely helped me get a good deal farther with this project. I unfortunately have been unable to locate information on how to retrieve the equivalent of 'show span' through SNMP.It may help if I e...
