I lost power while upgrading the Firmware in a 1310 while it was decompressing the .tar file. Now it boots and gives a message "no bootable files found and a bridge: prompt.Can I recover from this?

I need to connect 2 remote sites to a completely wireless bridged network that already has a root and 2 seperate double hops (no clients). Is there any limitation other than throughput to the number of wireless hops and the fanout (number or endpoin...

The 1310 supports 255 clients in Workgroup bridge mode. Can some of those clients be wireless clients on a 1230 AP with the 1310 registered to a different 1230 AP? Would the clients still be able to roam without problems?