About paul_brighter

paul_brighter · 04-07-2015

Actually, the LDAP authentication is working, which I can see with "debug ldap 255". However, the user is disconnected after LDAP authentication succeeds: [397] Authentication successful for ldaptestuser to XXX.XXX.XXX.XXX I'm not sure how to trou...

paul_brighter · 12-10-2014

Cisco ASA5505.I have a site-to-site tunnel set up from our office to our Amazon AWS VPC. I'm not a network engineer and have spent far too much time just getting to this point.This works fine from within the office, but remote VPN users cannot acces...

paul_brighter · 04-08-2015

I cannot figure out how to mark my reply to SHIBI V DEV as the answer.So creating this reply to mark as the answer telling you to look at my other reply.EDIT: OK. That didn't work either. Not sure how to mark my reply as the answer.

paul_brighter · 04-08-2015

Yes, AFAIK the authentication would not work with out the tunnel-group being configured. As far as ad-groups goes, this is not an Active Directory server. But you did make me look in the right place. I had: tunnel-group LDAP_GROUP general-attribute...

I cannot thank you enough. · 12-11-2014

I cannot thank you enough. That did it. Now I just need to do the same for our other VPCs. I know I need to clean up the address space, but I inherited some of this mess and wanted to make minimal changes until I got it working then double back and...

Member Since	‎12-08-2014 01:59 PM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	5

User Statistics

User Activity

troubleshooting LDAP authentication

Remote VPN users cannot access site-to-site tunnel

I cannot figure out how to

Yes, AFAIK the authentication

I cannot thank you enough.