Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I am at my wit's end here. I have searched this every way I can think of online and in these forums, so please forgive me if this has already been addressed. I just lack the terms to search it correctly.I have three sites with FTDs that are ma...
I have two FTDs, one with one ISP and one with two ISPs, and need to have failover tunnels between them. The internet connection fails over with SLA monitor and different metrics. The site-to-site tunnels are set up as route based with two static VTI...
@Rob Ingram I am not looking for load balancing primarily, although if I can accomplish that and the full redundancy I am seeking that would be great. What I am looking for is all potential peerings to be available in case of different combinations o...
Where I run into an issue is when in static routing I want to say that a subnet can be reached via two different gateways by the same interface I get an error message. Without doing this I am not sure how I can have a static route that traverses the ...
Turns out for this configuration to work I needed to set the secondary VTIs as "backup VTIs" in the VPN configuration. I had them set up as two separate tunnels, which for some reason didn't work. Thanks for the reply though!
