Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,I'm attempting to configure port security on 2950 with following commands: switchport port-security switchport port-security violation shutdown switchport port-security aging time 1440 switchport port-security aging type inactivityEx...
Personally I would agree with the comments of the last responder. If your network performance is OK you don't need to segment - and if your environment is switched throughout and you have low utilisation you really shouldn't need to.Obviously if you...
I have sticky addresses working, and I'm not too concerned about them being persistent after a reboot - I'm more interested in them aging. So I want unplugging node one and replugging node one to work, and unplugging node one and plugging in node _t...
This hasn't worked for me previously, but I'm trying it again anyway...I have turned on ``switchport port-security mac-address sticky'', set my aging type to absolute and set my aging time to 1 minute... The sticky MAC address is still shown against...
