Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When I configure APs, I make sure the switch port the AP is connected to is configured for access mode, on a VLAN that has DHCP, and has access to the internet. I usually use a vlan configured for user desktop PCs.
We have also used GRP and plastic boxes for indoor APs to be used outdoors and not seen any problems with signal strength. tested with the door open and closed without a difference in signal strength. if your curtain is large and heavy, there may b...
the antenna is a dual band, so each cable has a 2.4 and 5 Ghz antenna. the MR76 has both 2.4 and 5Ghz on each port, so every antenna port is exactly the same and you can connect the antenna cables wherever you want. you can connect a second antenna...
In the first two locations, using ANT20 I would say you are wasting a good deal of your signal strength by letting half of it go outside your intended coverage area. if you move the MR74s diagonally inwards instead of leaving them on the edge of you...
