Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
A consultant upgraded one of my 1231AG access points with an LWAPP image and no self signed certificate by mistake. Now the AP is locked into a reboot cycle and the ethernet port will not initialize. Is there a post anywhere or documentation on how...
I have an issue where I need to set up a site to site VPN with a partner company through a PIX. The partner company has a site to site tunnel with a vendor that is a duplicate subnet to ours (10.0.0.0/16). Can anyone point me in the right direction...
My company is trying to extend our network to remote offices in the US and abroad. I have seen several examples of configurations for single site to site tunnel termination, but never any for several remote tunnels back to one PIX. I would use the ...
Hi Rob and thanx for the response.Unfortunately, I have already tried this method without success. I keep getting something like "ethernet_init failed to autonegotiate" and then the ethernet port goes down. After that, the AP reboots.
Thanks for the input. I have seen that article and it does not apply to my situation. There is also an article regarding a PIX and a 3000 concentrator that is very close, but not quite what I am looking for. See this article also...http://www.cisc...
