Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to integrate Cisco DNA 1.2.8 to Cisco CMX 10.6.0-177. I have done the below steps. Nothing seems to work.
Step 1
SSH to Cisco CMX using a cmxadmin account. Enter the following command:
Step 2
Start the Cisco CMX API server. Enter the fo...
We have Cisco DNA Center version 1.2.5. I was able to upgrade everything except for the Network Controller Platform. We receive the following error:
System Readiness Check
- Catalog Connectivity (with an orange triangle)
- CCO Credentials (with ...
We have spun up a CMX 10.5 server. We tried to restore a backup of the old 10.4 server but it failed. So I connected the new 10.5 server to Cisco Prime and everything worked except licenses.
I tried to backup just the licenses on the 10.4 server b...
I have the Cisco DNAC and I am trying to integrate Cisco ISE with it. It keeps saying trust is not established. I have even upgraded DNAC and ISE but the same error.
Does anyone know of a solution or work around?
Thanks
Can I get the instructions for this? I have getting the below. Hopefully I don't have to build from scratch. CSPC 2.8 Don't boot we are getting the error:Telling INIT to go to single user mode.init: rc main process (xxxx) killed by TERM signal.Give ...
I am trying to but the only thing that I see in the Settings > Software Updates > System Updates is the Network Controller Platform. It will not allow me to download the Network Controller Platform.
I believe that this is not allowing me to see th...
