Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Using this equipment in my home lab for study purposes.I attempted to follow instructions I have found to send the asa traffic to the ips module for inspection. I command is missing for me.Commands I input on the asa: access-list IPS extended permit...
Using Cisco ISR 1841
I can see some traffic from the IPSec VPN on the wan interface when the other side tries to ping to printers on the local lan. There is no traffic from the VPN on the lan side. The tunnel shows to be up on both sides. The ot...
Well I just tried again and I do see it. I see they section it off and maybe I didn't see it before. I initially tried typing it in and it didn't work but maybe I typed it in wrong. I understand it is an older product but I would like to know more ab...
I used the same settings I could. LAN addressing on each side, encryptionDH group and all. Only difference is my public IP at my house that Ipeered to is different.
So I ran some other test. At home I have a Cisco 5510 ASA. I setup ipsec connections with similiar settings to the problem site and also the customers other 3 sites.
The problem site I get the same thing. I can bring the tunnel up but no traffic...
Yes pings from either end fail. What is strange is there is some trafficgoing to the printers on port 9100 which is a print job. Like there is ajob stuck in the print queue on the server because it keeps trying. Theprinter receives the tcp traffic...
