About pjgordon64

pjgordon64 · 11-12-2004

I am having trouble pinging any devices connected to an ethernet interface on a 2600 router. sh cdp neighbors doesn't show anything even though the ethernet cable is connected to a 2950 switch. Show interfaces has this information:ARP type: ARPA, A...

pjgordon64 · 11-17-2004

1. Yes, both switch ports are in switchport access mode.2. All switch ports are part of the same vlan.3. Cdp is enabled globally and on the switch ports and router interfacePaul

pjgordon64 · 11-15-2004

Oh, the down on the protocol was because I still had the cable out -- you asked something about if there was an error message when I removed the cable from the switch. It is normally up and up. Here is the correct output:FastEthernet0/0 is up, line...

pjgordon64 · 11-15-2004

This is what debug arp gives when I try to ping the host from the router:2d19h: IP ARP: creating incomplete entry for IP address: 192.168.55.10 interface FastEthernet0/02d19h: IP ARP: sent req src 192.168.55.8 0009.b77c.0420, dst 192....

pjgordon64 · 11-15-2004

No, I can't ping the router from the switch. I have tried switching the cables with the working ethernet interface and it doesn't help. The ip addresses and subnets are correct.I hoping against hope that there is another explaination other than har...

pjgordon64 · 11-15-2004

I don't have an ip address set on the switch. I don't think it is necessary unless I want to telnet into it. Is it?The topology is two routers connected by a serial cable. An ethernet cable on either router is connected to a switch. Each switch a...

Member Since	‎11-05-2004 09:54 PM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	6

User Statistics

User Activity

Ethernet Interface problems

Re: Ethernet Interface problems

Re: Ethernet Interface problems

Re: Ethernet Interface problems

Re: Ethernet Interface problems

Re: Ethernet Interface problems