Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello- We have 3 c220 M5 servers each with a VIC 1457 installed in it. I have it cabled like the following: PORT 1 - > Nexus N9k-9372PX Switch 1, 10g Port 1 (configured as standard trunk port)PORT 2 -> Nexus N9k-9372PX Switch 2, 10g Port 1 (confi...
Really old topic, but I found a working solution that doesn't require backing up config and rebuilding the VM. Follow these directions which were done on ESXi 8.03:
1. Power off VM in vCenter
2. Click on VM in inventory, the Configure tab, then vAp...
Yes. I made the changes after the initial install. I haven't went back to try to re-install after putting it to non port-channel mode. Perhaps that is the issue.
Yes. I can confirm that moving the cable back to the second port makes it go back down. The upstream switchports are very simple and look like the following: interface Ethernet 1/11description esxi01 vmnic1switchport mode trunkswitchport trunk allo...
I get it. I can confirm that it is at least "working" with the LRM and that the GUI thinks it supported. This is a temporary setup as we are awaiting some new Nexus switches and 25gb twinax for these. As far as the port channel, I agree that is h...
Actually the SFP+ module shows "Supported" in the matrix returned from the controller see below: We just moved the SFP from the second port on the card to the third (port-2 in image) on the card and the OS instantly saw that adapter as "Connected." ...
