Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Catalyst 4503 switch. When I reset the switch it boots to new configuartion wizard.I am writing the configuration to NVRAM using the wr mem command. I believe it may be to do with the config register:Cat4503#sh bootvarBOOT variable does no...
Need advice on PIX licensing.I would like to implement failover mode for my PIX 515E firewall that has a 4 port FE card. Currently using 4 of the six interfaces so the PIX is running an unrestricted license. I have another PIX 515E I can use, I j...
I currently have a PIX 515E to segment my college network. At present I have two inherited DLink 6000 switches, and switching packets between VLANs via the PIX can be slow at times. Is it possible to use a Cisco switch such as a 5000 series Catal...
So I still use the PIX to route (ooops) switch traffic between VLans so I don't need an RSM or MSFC for the Catalyst switch.I then configure the trunk link & VLAN port on the PIX and configure the trunk link, VLANs and MLS on the Catalyst switch port...
