Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
. I am running fcip on and I get a compression ratio of about 1.7, how can I improve this?The link is a 6meg link with a latency of 3-5ms under load.There are 3 fcip tunnels between 3 9509s and one 9216 on the far side, we are using EMC2 mirrorview
There are a few zones and zonesets that i have not created, but they still show in the sh run, and they show as active.When I try to delete those zones or zonesets i get an error "Zone/zoneset not present" What are these and how you clean them?Thanks
I have a tape library that has multiple i/o blades (Bridges) linked by a backplane, and the robotics gets advertised on all ports on all the I/ blades for "redundancy" so says the vendor. The problem is that the robotics can only receive control, or ...
I have a kiwi syslog server on a windows 2003 server to which i can not get my switches to send messages to it.can someone please help.I tried to configure from the cli and from the DUI without any luck.
also look at you retransmits, mtu and set both the cwm and send buffer size to 0. and then start looking and playing with it.I do not get good compression from Cisco neither,I do MUCH better with my old CNT boxes.
which mirrorview?if sync then you should turn WA off because cisco's WA engine is not consistent.if Async, i would try putting the compression on auto and see what happens.
What I am thinking about is to trunk a couple of ports between MDS1 and MDS2 and use FPSF so there will be 2 fcip links set at 10Megs but use just one using rout costing.Do you think that this would work.
The actual topology is like this mds1-mdsdr use fcip2 with 5megsmds2-mdsdr use fcip3 with 5megsin mds1 I have the replication port-A for all the source arrays.in mds2 I have the replication port-B for all the source arraysIn mdsdr I have the replicat...
