About Antaean

Antaean · 02-01-2023

When I start a configuration using the default config, all ports are up if plugged in. After the default config is finished, I make the following changes. Go into each interface (2 -  remove nameif, remove bridge-group, and shutdown. After the int...

Antaean · 02-02-2023

Yes this is the first time I tried to remove a BVI on 9.16. In the past I did it on 9.10. I have gone back to the interface and re-entered no shutdown. I have read the article at Petenetlive.com in the past. I have done all that is listed.

Member Since	‎04-05-2018 04:26 AM
Date Last Visited	‎03-03-2023 12:43 AM
Posts	2

User Statistics

User Activity

all interfaces down after removing BVI1 on cisco 5506

Re: all interfaces down after removing BVI1 on cisco 5506