Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,Currently we have Cisco FirePowers as our VPN connectors and using Anyconnect as out VPN client. We are using Microsoft NPS for Radius authentication with AD and Microsoft Authenticator for MFA.We are looking to introduce the number challenge ...
I have a remote site with a Cisco 1010 FirePower connected to our main datacentre via a Site-2-Site VPN....The 1010 FTD is managed via the FMC located in our datacentre. I had to make a change to the DH groups on the VPN due to certain groups being d...
If anyone needs to know how to configure this i.e. Outside / data interface to be the management interface.... Go to the online help within the FMC and navigate to help_files/index.html#!t_change-the-fmc-access-interface-from-management-to-data.html
Hi Rob, Thanks for your responses.... Can you expand on the first sentence above please???? I'm intrigued.... I will try to explain how ours is currently setup: The Management interface is physically connected back into one of the standard interfaces...
It's a bit a flaw in the design don't you think....... Everyone makes mistakes from time-to-time and if you deploy a policy that may take the FTD offline for any reason, the only way to change the config back is to return it back to the datacentre an...
Looking at the NAT'ing at the remote FTD I think its the return traffic which is routing back over the S-2-S VPN because of a global NAT being above the FTD management one..... I had thought of amending the running config of the remote FTD and upload...
