Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi collegues,I am trying to set the metric of an OSPF route using a route-map with a set metric command I used the commands as followsrouter ospf 100distribute-list route-map set_metric inroute-map set_metric permit 10match ip next-hop X.X.X.Xset met...
Hi Mohamed,I did try using the ospf cost command for the secondry interface and it did acheive load balancing over the two paths for ouging traffic, but by doing this on the Secondary interfaces of all the sites it caused an unpredictable routing beh...
Hi,I am trying to load balance on two unequal cost paths advertised within the OSPF, I know that the EIGRP can do that but I want to acheive the same result on an OSPF cloud.The Scenario I have is 2 redundant routers (primary & secondary) with HSRP o...
