I am trying to apply the instructions using the following h/w:
Switch: C2960S Software (C2960S-UNIVERSALK9-M), Version 15.0(2)EX5
AP: C1600 Software (AP1G2-K9W7-M), Version 15.3(3)JC
I can type in all the commands, except for this command on the switch port:
switchport trunk encapsulation dot1q
This command is apparently not supported by the switch.
Ultimately, the AP broadcasts both SSID's, I can authenticate a client to both of them (I can verify this because both SSID's authenticate users using a RADIUS server) but in only one of them will the client get an IP from the DHCP server.
Interestingly, the ssid that works is assigned the non-native trunk vlan.
... View more