Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I want users on the inside 192.168.1.0 to access any resource on the outside 10.15.0.0 and then allow selective users on 10.15.0.0 to access resources on 192.168.1.0. Is it possible to do it? Running config is as follows: ASA Version 7.2(3) !hostname...
Router1: 168.206.8.1Router2: 168.206.8.65Router3: 168.206.8.202Router 1 and 2 exchange CDP info. Router3 show cdp traf: Total packets output: 1036, Input: 0 All the router can ping each other. Any ideas why router3 doesn't show any neigh
HiWhat router would you recommend for the following setup/change1 existing network that must be split into 4 new subnets Routers must be configured with static routes with 1 smart router (5 routers in total)Uplink: 1Gig fibre optic cable with LX conn...
Hi PR1: 168.206.8.1/21 Eth0 (1605)R2: 168.206.8.65/21 FA0 (1721)R3: 168.206.8.201/1 FA0/1 (1841)R1/2 & 3 is connected via ethernet cable and 3Com 4400 switchesRouter 1: show cdp neighbyyy Eth 1 159 R 1721 Fas 0Router 2: show cdp neighbyyy...
Hi AnkurCDP is enabled on all the routersR1/R2/R3: show cdpGlobal CDP information:Sending CDP packets every 60 secondsSending a holdtime value of 180 secondsSending CDPv2 advertisements is enabled
