Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a WLC2504 version 8.2.141.0 with 20 AIR-CAP1702I-A-K9 and AIR-AP1832I-A-K9, the Vlan is default in the networkFor two years I worked well then, nest stopped being recognized little by little, now I don't see any of them, it's not a network pr...
No changes have been made and this was working fine for a while and suddenly all of them have gone down with no discovery on controller, below errors are shown in CLI of the cisco AIR-AP1832I-A-K9, the CLI of the controller no report problem. Can any...
The WLC2504 controller has been working fine with about 20 Access Points, little by little I stop seeing all the Access Points, now it doesn't see any APsFor that reason we disconnected two APs from the Network and we have connected it directly to po...
These APs work well in other controllers, for all cases we use a single VlanBelow you can see some commands: (Cisco Controller) >show cdp neighCapability Codes: R - Router, T - Trans Bridge, B - Source Route BridgeS - Switch, H - Host, I - IGMP, r - ...
