Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I'm not sure if this is possible but wanted to ask the question before asking specifics. Here's what I'm trying to do:Have EEM w/IP SLA monitor an existing network connection. In the event the remote side becomes unreachable I need to run a scr...
At the moment I can’t look closely at the config but off the top of my head I see you’re trying to go into configuration mode without first entering enable mode.Issue “enable” action on the line preceding “conf t”.You should use a different labeling ...
