Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
I am running some spanning tree loop issue on my switches
We have 2 sites connected with metro ethernet link
On each site we have cisco 3850 stack switches
On each site we have 2 links from different service providers connecting site A and sit...
Hello All
I m receiving routes on router 2 from router 1 ranging from 10.104.1.0/24 to 10.104.140.0/24
but i wana advertise only advertise routes from 10.104.111.0/24 to 10.104.136.0/24
i want to create prefix list so i can apply that on route-map a...
Hi All
I m running output drops issue on cisco 3850 stack wise
I have created ether-channel and there are 4 ports bundled in it
actually we are getting alert from Op Manager ( monitoring Tool ) that we reach 87% discard rate
this port-channel are ...
i tried changing speed and duplex full but didnt worked
also i tried flex interface but i think this command is not supported on 16.3.6
switch is not accepting switchport backup interface gx/x
on server side we created LAG as well and 4 ports are connected so in my understand when we create etherchannel it also do load balancing and also if u see the drops we get drops on each interface as well
show int gig1/0/14 controller
GigabitEthernet1/0/14 is up, line protocol is up (connected) Hardware is Gigabit Ethernet, address is 0045.1d05.e10e (bia 0045.1d05.e10e) Description: VRTXA INT Port 2A (HOSTA02-HVLAG) MTU 1500 bytes, BW 1000000 Kbi...
