Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello ,We have 2 Cat6509 switches witch are connected by an etherchannel.When one port / link in the etherchannel is disconnected it takes 500 milisec to 1 sec before the session is switched over to the other link in the etherchannel.The requirments ...
when i switch to mode on, the channel is using PAGP and i want to use LACP. I also used the command channel-protocol LACP, but then the switch gives an error that its using PAGP. (I want to use LACP because in the future i want to connect to an Alcat...
hello Edison,In the attachment you can see a drawing of the test i've build. I simulate traffic with an Acterna tester on both sides (this is onlu one session). Between the two 6509's is a port-channel with 2x 1GE.When i send traffic both the links a...
