About uitmorand

uitmorand · 12-12-2011

Hello!I am trying to set up an ACL on our Cisco SG 300 switch. I want to create an ACL that enables hosts on our guest network to obtain IP addresses from a server on our "internal" network but they should not be able to reach any other resorses on t...

uitmorand · 03-16-2011

Hello!I have a question about ACL and binding. I have a SG300 28P and a couple of other linksys switches and Access points that are connected to it via trunks. The cisco SG300 28P is running in layer3 mode and i have created a couple of vlans and on...

uitmorand · 12-13-2011

Thanks for your suggestion. I have used it with some small changes, and it works perfect. I uppload a picture on my config so you can see. The ACL is only permitting DHCP and DNS traffic between the guest network and the internal.Tanks again./MorganS...

uitmorand · 12-12-2011

hello!Tanks for your replay. The switch is configured to run in Layer 3 mode and one interface at each V-lan is default gateway. I want to configure an ACL that function so it only alow DHCP trafific from V-lan 4 Guest to V-lan 3 internal. It shuold ...

Member Since	‎03-15-2011 06:12 AM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	4
Total Helpful Votes Received	5

User Statistics

User Activity

ACL config on SG 300 28P

ACL binding on SG 300 28P

Re: ACL config on SG 300 28P

Re: ACL config on SG 300 28P