Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello appreciate any help from the cisco gurus out there,
i am trying to setup two ports on a stack of 3750 switches via link aggregation using LACP. The config currently in place is:
interface Port-channel6 description backupmedia switchport trunk e...
Hello Paul,
Thanks for your quick answer.
Can a channel group setup in LACP mode conflict with a channel group setup in "On" mode on the same stack of switches?
Thanks again
Laurent
I managed to upgrade the latest BACS thanks for that. I'm unsure about the config syntax...Is this the right lines to use for active mode? Do I need to activate LACP globally? Last question...As this will be used to setup 2 in one team accross a stac...
