Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I was given a 2911 Router with a SM-ES2-24 Service Module. When I attempt to session to the SM, it is asking me for a username/password. How do I delete the configuration of the SM?
I have a 3750 switch with two 48-port switches connected via stacking cable. On these switches I have two VLANS: VLAN100 for data, and VLAN300 for Desktop VTCs (dVTCs). I configured the switch with VLAN 100 having an ip address.I have verified:-IP...
I have a 3750 switch with two 48-port switches connected via stacking cable. On these switches I have two VLANS: VLAN100 for data, and VLAN300 for Desktop VTCs (dVTCs). I configured the switch with VLAN 100 having an ip address.I have verified:-IP...
I have a Cisco 2800/2900 router that handles sensitive information for the DoD. If I do a "clear config all", will this delete the running config permanently or is there a way that someone can recover the config?
I have a 3750-48TS switch that has a port that is constantly cycling amber to green to amber etc. I currently have the port set for 100/full and have verified the workstation is also set for 100/full on the NIC. I have tried setting the port to aut...
I tried creating the static arp using this command:arp 11.XX.XX.74 <mac> arpa g0/0.300and I received the following error:"Bad ARP command - Interface may only be specified when bridging IP"
So after doing all the pings, I was not able to get any replies (from the dVTC to the SVI [.76] and the gateway [.73] and nothing showed up in my arp debug on my router and switch as I was attempting the ping
