Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I've 2 Cisco switches that I configured at the same way, the have both the same IOS image, but when I do a "show run" in one of the switches the VLAN are shoed (not the VLAN interfaces) but in the other not.
What could be the problem?
SW1
!
no...
I'm sure that in the Switches also the VLAN6 was configured because the router on both end can use that vlan to ping each other, in fact using "sh vlan" they were shown correctly.
I don't want to use VTP so I gave the command "vtp mode off". Is the domain set that let me to see the VLANs in the config file despite I deactivated VTP?
