Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi. We have a CSS setup with only one ethernet port(eth1) ,one arm configuration.This port is ingress aswell as egress for loadbalancing traffic.It takes in client request from various sources and load balances to services on the same network.For E.g...
Hi NetProsI have two 5540 connected to a pair of 3750 stackedI have established trunks with the pair of 5540s in active/standby and 3750 stacked switchesMy configuration on ASAs is below---------------------------------------------------------------...
Hi Could someone please explain me the differece between Maximum firewall connections and Maximum firewall connections/secondFor eg. 5520 can have 280,000 max fw connections and 12,000 max fw connections/secondHow is this calculated, what is the di...
Hi GilesThanks for answering ..About the split ingress and egress design..Do I just need to configure another eth interface and assign the same vlan to it. Will that split the ingress and egress traffic. or Do i need to do something else.Much Appreci...
Thanks for the explanation Dario.. I have a 3750 WS-C3750G-48TS with c3750-ipbasek9-mz.122-40.SE running on it and I cant seem to find the commands to make a promiscious trunkswitchport mode private-vlan trunk promiscuous andswitchport private-vlan...
Thanks alot Jorge..FYI here is the link which was the cause of my confusion.. if you scroll right at the bottom you will see a conclusion with a reference to a TAC case.. I typed these words in google "same-security-traffic permit inter-interface tru...
