Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Cisco Incident Control System (ICS) is the software product in our outbreak prevention solution. It deploys Outbreak Management Tasks (OMTs) to Cisco IPS sensors and Cisco routers on your network. OMTs deploy new ACLs on Cisco routers and tune the 50...
There was a defect affecting IDS MC versions 2.0 and 2.0.1 that would cause the behavior you are seeing if you are using the CiscoWorks certificate.If you are running an affected version, go into VPN/Security Management Solution > Administration > Co...
A possible cause could be that you have network cables plugged into the wrong network interfaces on the back of the IDS-4215. Beginning with IPS 5.0, on all existing sensor appliances, we name the network interfaces according to a Cisco standard. For...
This is most definitely an issue that we can best address via a call to our Technical Assistance Center. It is doubtful that the event filters were in any way responsible for this behavior. While you have the serial console connected, you might want ...
As shipped, the SSH server will allow SSH1 and SSH2 clients to connect to the sensor. You can disable one or the other using the service account, and editing /etc/ssh/sshd_config. For example, to disable SSH2, change the line:#Protocol 2,1toProtocol ...
