Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Connecting to sandbox-iosxe-recomm-1.cisco.com with username developer and password lastorangerestoreball8876. Logs in but then when I try to go into enable mode with the same password it says Access Denied.
We have two ASA5520's in a active/standby configuration. We have been unable to use any of the show commands. Everything else seems to work ok but if we want to look at the running-config/startup/interfaces etc, anything that uses show, it just sits ...
It is happening on both the active and standby firewalls. We think we have found the issue. It seems to be SSH v2 is causing the problem as we have been able to connect to a directly connected switch and then TELNET from the switch to firewall. All t...
