Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,as Iv read in doc related to CSS failoverThe Cisco WebNS software allows you to:-configure multiple uplink services -use failover based on a link going downCan someone explain me these two possibilities?Pls. send me config example.BRgg
Hi all,we are considering to connect two CSSs or ACEs in box-to-box failover. The failover link between both balancers.From inside site we want to connect 2 switches as in standard triangle manner in LAN to both balancers.My question is if the balanc...
Hi all,Iv read a many about failover cabling so pls. give me advice for next:We have two boxes of ASAa so no connector for serial cable as in PIX was and we want to configure these ASAs in stateful failover:Cisco says ... Instead of using a crossover...
Hi Gilles,Iv found that CSS is possible to configure via XML. Do you have any experience?As I understand its not necessary restart CSS. So it sounds good.BRgg
Hi Gilles, any other useful tool pls.Yes, you are right that it is possible to SSH to router, switch and put some commands but I have no knowledge with CSS.So my question was if something special is over there to help us.BRgg
Thanks.Yes, thats what we want to achieve. We need to send some specific traffic going out in PIX from VPN to send it to Internet not to our localnetwork. So as I understand we can do it with only commands you send me.BRgg
Any idea how to route traffic coming from VPN to PIX (going out of VPN) back to Internet?So I will see traffic in Internet like our public IP address.BRgg
OK. Quite an interesting discussion. So as I understand 2 switches is the best solution and two cables is the cheaper choice.I have the other question. We want to connect both ASAs to our inside network trought switch.Is it possible to double switch ...
