Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am trying to perform a downgrade of PIX515E from version 7.2(2) to 7.0(4). I have found some info from the link http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a00804708d8.shtml#t6. The procedure shows downgrade of ...
Hi, we are trying to configure trunking on Catalyst 3750 so that our Dell switches can retrieve the VLAN information from the Catalyst. However, we need GVRP to be enabled on the Catalyst. Is there any way we can do this? Thanks.
Hi,We had previously upgraded our PIX from version 6.3 to 7.2 and was successful in doing so. Recently we tried to upgrade from version 7.2 to 7.4 but the PIX still shows 7.2 after the upgrade steps have been performed. Appreciate any advise. Thanks.
Yes, you are right. I have tried the downgrade command and the PIX doesn't allow me to do that. It gave me a message saying that the downgrade command is only for version 7 to version 6. The thing is, the flash memory is not enough to hold both 7.2(2...
I have checked and found that the image.bin was created in September; I guess it was created when we performed the upgrade from 6.3 to 7.2 previously. How do we flush that out? Thanks.
