Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am running an 881W on 12.4(20)T3I can't figure out how to configure the internal access point. All the guides that I see out there say to log in via service-module wlan-ap but this is what I get:tciao#service-module wlan-ap 0 sessionIP address nee...
I ended up setting the BVI1 interface address in CCP. I then telnetted from my PC to that address. I had to login with cisco/cisco even though I had already setup a different username. I then had to enable the secure http server before I could con...
