Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
Just wondering if anyone could help me with regards to adding a FQDN to a split tunnel VPN. I have tried adding the FQDN as we would usually via an object-group and then binding that to an ACL and when I apply the ACL, I get an error message...
Hi Enjama,
It looks as though your security levels are incorrect. In order to let data flow between interfaces, please could you assign the inside interface a security level of 100 and your outside interface a security level of 0?
It may also be wor...
It will be an issue most likely with your NAT's. In pre-8.4 configuration you need to specify the NAT'd IP address in the ACL, rather than the real IP.
Interesting, have you got the access-group applied? I can't see the configuration in the new up to date configuration you sent.
"show run access-group"
