Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, Im having a lot of trouble setting up an ASA 5505 in Packet Tracer v7
I keep getting the same message when in Simulation mode "The ASA does not allow and traffic from a lower security interface to a higher security interface unless it is expli...
I am configuring the network attached in the picture.
I cannot get any of the PCs (specifically the Management PC) to ping the Server Farm
I have tried creating routes on LE-Office Router and LE-Server Router however it still fails.
LE-Office Router ...
Hello.
Im struggling configuring a network in Packet Tracer (v7).
I have a router(2911) and some switches(2960-24TT).
I have configured dot1Q on the g0/0 interface of the router and created 6 sub interfaces. each sub interface has been assigned a di...
finally found a solution thanks to one of your comments.
you said it would auto forward to the inside interface so i changed each side to be a 252 mask and reconfigured the ip address.
I had it as a 248 network due to an earlier error where it wouldn...
This is one of the main issues. I dont need it to connect to any non directly connected subnets.
I removed the inside default route and now it wont ping past the firewall.
I have included the packet tracer file i am using inside the zip. Using Packe...
Added that command after reading the link you provided.Still having some issues however.
The ping can only travel one way.
This is due to default route being set to "route INSIDE 0.0.0.0 0.0.0.0 77.97.151.4 1"
im not sure how to rout both incoming tr...
I noticed the ip route was not being applied.
I have re applied the ip route and then set a default gateway on LE-Server and it appears to be working now.
Thank you for you help.
