Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good Morning,We are looking at upgrading our WAN between our Primary Datacenter and Secondary Datacenter to gig using licensed wireless equipment. I have been looking into firewalls to run between the two sites and it looks like for Gig connectivity...
Good Morning,I have a 8T1-IMA card that I am using to bond 5 T1s togeter in an IMA group. After speaking with our service provider they believe that the clocking our our router is not setup correctly which is leading to the ATM circuit not coming up...
Good Evening,I have a 3825 router with a NM-8T1-IMA NM module configured as follows:interface ATM1/0 no ip address ip pim sparse-mode no scrambling-payload ima-group 0 no atm ilmi-keepalive clock source lineinterface ATM1/1 no ip address ip pim spars...
Hi Karthik,I would be looking at the throughput specs for the firewall. If I'm not mistaken once you startEncrypting the traffic though a site to site VPN you would have to look at the 3DES/AES throughput on the firewall? Thank you,Justin
Thank you for the link as well. After looking at this I just wanted to confirm that I am installing the 8T1-IMA in a Cisco 3825. This appears to be on the supported hardware list, as well as the 3640 that I am using to test with. The 2800 series t...
Thank you for the quick response. I have a 3640 with the same module which I also attempted to bring the circuits up on and received the same errors, which leads me to believe it would be a configuration error, although I could be wrong.At the momen...
Just a quick update on this. Worked on the issue some more tonight. I am able to get this to work back to back between a Cisco 3640 and the Cisco 3825. I was able to replicate the same issue with a Cisco 3640 onsite as well. After speaking with Q...
Took another stab at trying to get this to work last night and was not able to get the ATM interfaces to come up/up. If I removed the ATM interface from the IMA group it did go up/up, so it appears to be that the framing, etc on the T1 is correct. ...
