Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi all,I have a WLC 2106 and 1242AG.it's a hotspot configuration.So in WLC, under controller tab, i have set my ap-manager ip, my management ip, my virtual ip (1.1.1.1) and my hotspot network range ip.I set also a DHCP range for the hotspot network.I...
Dear Sender,The procedure to submit a request for Firewall Request has changed.You have now to write your email to the following email address: [email protected] Not use anymore the previous email address: “[email protected]...
hi all,just for a more precise answer.In fact it's working with the catalyst express 520. Yes i know i am not friendly with this kind of switch ...On my catalyst express 520, i have 2 vlans. One for the management of the AP, the other for the hotspo...
hi all,This morning i changed my catalyst 520 express by a catalyts 2960G. And "OH my god", it's working very well, with many user in same time ...So I took my catalyst 520 express and I put it in the trash .. the right place for this kind of switc...
hi,Yes i have nat on my external interface.I have try with other wired clients network and all is ok for internet access.I saw the address translation on firewall log.I will try with an other SSID.I made debug on WLC, and i didn't see aaa trafic from...
In fact,i have 3 AP 1242AG , 1 WLC 2106, oand One Catalyst express 520.I have configure on Catalyst 520 2 vlans ( administration and wifi hopspot)Port 1/2/3 of catalyst are for AP with poe in vlan Administration, port 5 for WLC administration vlan.Po...
