Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am trying to create a network in which there are four bridges communicating wirelessly in point to point design(Two bridges on each end of the network which are the connected to Catalyst 3650 switches). I have achieved this design but when I ...
Thanks Dan I have tried it with layer 3 etherchannel and used the eigrp routing protocol to route between the different networks and it works now, I noticed both links were utilized but I am going to try it with a bigger file to see if it will perfo...
I have tried it with layer 3 etherchannel and used the eigrp routing protocol to route between the different networks and it works now but I am going to try it with a bigger file to see if it will perform better.
Your answer fits the description of the problem I am facing. If I remove the ethernet cable connecting on of the wireless bridges, data trasfer stops and does not continue with the inactive link unless I start the transfer again.I am using cisco airo...
Thanks Dan, I will try and use that idea but is there anyway I can get some info that will help in designing the network to behave in that manner. Another things is since a layer 3 switch can perform routing can I just use one switch on each end just...
Thanks scott is there anyway I can use a switch to accomplish this or to combine the links to achieve aggregated throughput.I am using cisco aironet 1300 wireless bridges.
