Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I would like to insert an ASA 5510 into our network in transparent mode. I would like to begin by allowing all traffic to pass between the two interfaces unrestricted. How would I go about doing this?I currently have access lists on both interfaces...
All:I had found resolution on another thread, https://supportforums.cisco.com/message/1284803#1284803.It looks like telnet/ssh on the 521 is for viewing/read-only. I have since been purchasing the 1242 series that allow full access. Best regards,Mik...
David,I was just about to post the same exact question. I have had this issue on two 521 APs. The first AP was autonomous from the factory. The second AP was downgraded from lightweight to autonomous. Same problem with both of them. No "config t...
