Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am configuring a Cisco 1130 access point and somehow a Dot11Radio1 got enabled, I need to remove this from the configuration and just leave Dot11Radio0 working.when i try I get the following error.APxx(config-if)#no interface Dot11Radio1% Removal o...
My issue is the Server I have that manages all the wireless access points is alerting me that a port(Dot11Radio1) is down and disabled when really it does not need to be there. I have a number of 1130s that don't list this second radio in their confi...
I have a number of these Access Points installed and only 2 of them show this Dot11Radio1 interface, the rest only have Dot11Radio0, it's some side effect of when I reconfigured them after they were already configured.LeoLahoo I tried the command the...
That didn't seem to work:APXX#conf tEnter configuration commands, one per line. End with CNTL/Z.APXX(config)#interface Dot11Radio1APXX(config-if)#default interface Dot11Radio1Building configuration... not allowed on Dot11Radio1 interface not allow...
