Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
While attempting to load a yang model (Cisco-IOS-XE-vlan) from a set in the Netconf configuration area of Yangsuite, the application just hangs. I have no recourse. I've tried stopping and re-starting the Yangsuite container. That did not work. Here ...
Hello all,I am new as a Cisco admin and a recent CCNA. I have a perplexing problem. Recently we experienced a power loss in our switch core which consists of Catalyst 3550 switches. All links came up after power was restored except for two. One was a...
I had tried other modules before that issue with success. After that issue and when I was able to recover the interface, I tried loading the vlan module again and then left to go do something else. When I came back, it was loaded. I have no idea how ...
Giuseppe,Yes, my cables are Ethernet copper, Cat 5. Speed and duplex are auto on every port. The Procurve was connected to the 2950 end of the link and yes, on the 3550 the same port is used as before. However, while troubleshooting I did try a diffe...
