Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I setup a cpu ACL for specific IPs and everything works fine. However, I can see counters go up but there are no logs being generated. I tried looking at "debug packet logging" but I never got a log showing which IP address was being denied.
Hello,
I'm trying to set RADIUS over IPsec between a WLC 5520 and Windows Server 2016.
The RADIUS part works fine on it's own. My problem is I can't make the IPsec protion work at all.
I have found an old guide but it seems that too many things hav...
Hello,
Is there an option to enable CRL check on an AP and controller running on 8.5?
I have LSC enabled and was able to issue certificates to both the AP and the controller with the CDP extension present in both but I don't see an attempt to fetch...
Hello,
I'm using 8.5.131 and I can't figure out how to block clients from joining a WLAN for specific time and day.
I created an ACL that denies everything inbound and outbound. Then I create a local policy and just set the ACl, the time and days and...
it gives me the same log:*pktDebugSocketTask: Mar 07 10:56:31.906: PKTDEBUG IP ACL returning action deny from rule 1is there no way to get a specific log for each denied IP addresses?
Hi Flavio,
Thank you for your response. There are no routing done between the 2 devices and no ACLs being used.
I have tested the RADIUS part and that works fine.
