Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to configure DHCP relay through VPN, I read different articles, but I cannot figure it out:The setup is as follows:Site1:DHCP server: 192.168.200.21Cisco 877 ADSL routerInternal IP: 192.168.200.12External IP: 194.99.99.194Site2:Cisco 5505...
I have the following setup:ADSL ---> Cisco 877 with connected site-to-site VPN's ---> Cisco ASA 5505 with Remote VPN enabledI want to connect my Android phone to the Cisco ASA 5505 with Remote VPN. When I forward port 500 and 4500 on the Cisco 877to ...
In addition, PXE boot is also possible, I enabled option 066 in dhcp and specified the ip address of the SCCM 2012 server, plus enabled 067 with the "SMSBoot\x86\wdsnbp.com" entry
Hi Daniel, I added the NAT entry but still no luck, so config post time:Router Site1:!This is the running config of the router: 192.168.200.12!----------------------------------------------------------------------------!version 12.4no service padser...
Ok tried some stuff, to make it work I used access lists and now its working:1. Port forward the vpn ports to the ASA:ip nat inside source static udp 192.168.200.14 500 66.66.66.66 500 route-map static-nat reversible extendableip nat inside source st...
Hi vincent, I tried your settings but then internet does not work anymore and the vpn's are lost....if I deletethe two static nat lines (500/4500) everything works again, what am I doing wrong / is missing in the config ?config: (66.66.66.66 = exter...
