Acerca de jozef.mozolik

jozef.mozolik · 09-26-2010

Hi All,I have the following topology:DEVICE X <---- trunk vlan 10,20,30 ----> in.p C4500 out.p <---- trunk vlan 10,20,30,40,50 ----> DEVICE YI need to change the cos value for specific vlan (vlan 20) on Catalyst 4500. But only for vlan 20.Received c...

jozef.mozolik · 07-17-2009

Hi All,I have the cisco switch WS-C4948 running IOS 12.2(46)SG and local span session configured:sw-4948>show monitorSession 6---------Type : Local SessionSource Ports : Both : Gi1/5-11,Gi1/21Destination P...

jozef.mozolik · 05-11-2009

Hi All,starting debug ip routing I am observing the following message every 60 secs in my buffer log:RT(VRF): NET-RED 0.0.0.0/0There are only 2 static routes configured, no any dynamic routing protocols.What this message means exactly? Is there any c...

jozef.mozolik · 04-14-2014

Hi All, thank you for the quick reply, we have implemented exactly the same workaround finally. authentication-failure + redirecty to second proxy/port with different auth group configured. regardsjm.,

jozef.mozolik · 04-10-2014

Hi ,we have the same problem with ACE30 A5(2.1e). Did you find a solution for your problem? Thanks for any ideas. thanksjm.,

jozef.mozolik · 09-30-2010

Hi All,by mistake I've omitted the line in the config qos map cos 0 to dscp 46, the result was - wrong conslusion. Finally the conclusion is:- it's not possible to change COS value (example incomming cos=0, outgoing cos=5) using the configuration abo...

jozef.mozolik · 09-29-2010

Hi Allapplied configuration works well when the input port is on the linecard, IP traffic(icmp) and non-IP traffic (ARP) is remarked by cos=5 as it is expected. But the same configuration is not working if the input port for vlan 20 is on the supervi...

jozef.mozolik · 09-28-2010

Jon,it is working as it is expected, cos remarking is done for IP traffic and non-IP traffic too (ARP packets). The only way how to check it was to configure local monitor session on c4500 (with 802.1q support) and to sniff traffic under linux/wiresh...

Miembro desde	‎05-11-2009 11:52 PM
Fecha de la última visita	‎08-18-2017 03:53 AM
Mensajes publicados	12

Estadísticas de usuario

Actividad del usuario

How to alter the cos vaule on the frame switched by the c4500?

Local SPAN on 4948, amount of traffic is not equal

RT(VRF): NET-RED 0.0.0.0/0 - every 60 secs.

Hi All, thank you for the

Hi ,we have the same problem

Re: QOS - linecard ports vs. supervisor ports - UPDATE FINAL

QOS - linecard ports vs. supervisor ports - UPDATE

Re: How to alter the cos vaule on the frame switched by the c450